Tonga Trench

From Wikipedia, the free encyclopedia

The Tonga Trench is the northern half of the Tonga-Kermadec subduction system which extends 2,550 km (1,580 mi) between New Zealand and Tonga. [1]

The Tonga Trench is an oceanic trench located in the south-west Pacific Ocean. It is the deepest trench of the Southern Hemisphere and the second deepest on Earth. The fastest plate tectonic velocity on Earth occurs as the Pacific Plate is being subducted westward in the trench.

When the Apollo 13 mission was aborted in 1970 following an explosion in an oxygen tank, the radioisotope thermoelectric generator broke-up in the atmosphere and the heat source plunged in or near the Tonga Trench. Atmospheric and oceanic monitoring indicate no release of nuclear fuel has occurred. [2]

Horizon Deep

The deepest point of the Tonga Trench, the Horizon Deep at 23°15′30″S 174°43′36″W / 23.25833°S 174.726667°W / -23.25833; -174.726667, is 10,800 ± 10 m (35,433 ± 33 ft) deep, making it the deepest point in the Southern Hemisphere and the second deepest on Earth after the Challenger Deep in the Mariana Trench. It is named for the research vessel Horizon of the Scripps Institution of Oceanography, the crew of which found the deep in December 1952. [3]

As one of the deepest hadal trenches, the sediments of the Horizon Deep harbours a community of roundworms. A 2016 study found that the abundance of individuals in this community is six times greater than it is at a site on the trench edge ( c. 6,250 m (20,510 ft)) near the deep and that the difference in biomass between these locations is even bigger. Species diversity, on the other hand, is twice as big on the trench slope, probably because of a small number of opportunistic species in the trench. [4] Figures for abundance and biomass are similar for the deeps of the Mariana Trench but considerably lower in the Peru–Chile Trench. [5]

Geology

Tonga-Kermadec arc system

The region between the Tonga trench and the Lau back-arc basin, the Tonga-Kermadec Ridge, moves independently from the Australian and Pacific plates and is subdivided into several small plates, the Tonga, Kermadec, and Niuafo'ou plates. The Tonga Plate is facing the Tonga Trench. [6]

The Tonga Trench-Arc system is an extension-dominated, non-accretionary convergent margin. The Pacific Plate is being subducted westward in the trench. The convergence rate has been estimated to 15 cm/year (5.9 in/year) but GPS measurements in the northern trench indicate a convergence rate of 24 cm/year (9.4 in/year) there. [7] This is the fastest plate velocity on Earth, a result is the earth's most active zone of mantle seismicity. [8] Subduction rates decreases southward along the Tonga-Kermadec Arc, from 24 cm/year (9.4 in/year) in the north to 6 cm/year (2.4 in/year) in the south and also becomes more oblique southward. The high rate in the Tonga Trench is largely due to a reduction in extension in the Lau Basin. [9] Crustal extension in the Miocene Lau-Colville Ridge began at 6 Ma which initiated the opening of the Lau Basin-Havre Trough. This extension has propagated southward since and has developed into a spreading centre in the Lau Basin in front of the Tonga Trench. New crust is thus produced in front of the Tonga-Kermadec trenches while old crust is consumed behind it in the Tonga Trench. [10]

Pacific slab avalanche

While most of the large earthquakes occur at the contact zone between both tectonic plates, related to the friction during subduction, others are produced in the Pacific plate due to its bending. [11] The Pacific crust that descends into the trench is old, 100-140 Ma, and relatively cold and it can therefore store a lot of elastic energy. As it reaches deep into the mantle, more than 600 km (370 mi), and encounters barriers, it is being contorted which produces deep mantle earthquakes. [12]

c. 500 km (310 mi) beneath the North Fiji Basin a detached segment of the subducted Australian Plate has collided with the subducted Pacific Plate which produces many large-scale earthquakes. The subducted Pacific Plate is also being deformed in the collision as both slabs settles on the 660 km discontinuity. This slab collision probably occurred 5–4 Ma when the Lau Basin started to open. [13]

Oceanic trenches are important sites for the formation of what will become continental crust and for recycling of material back into the mantle. Along the Tonga Trench mantle-derived melts are transferred to the island arc systems, and abyssal oceanic sediments and fragments of oceanic crust are collected. [7]

Tonga Trench–Lau Basin transition

At its northern end the Tonga Trench bends west into the microplates, interconnected spreading centres, and deformation zones of the Lau Basin. But the Tonga trench also has a continuation in the inactive Vitiaz Trench (north of map area) with which it formed a single continuous trench before the opening of the North Fiji Basin (west of map area).
The Capricorn Seamount (centre right) is sitting on the eastern slope of the trench.

The northern end of the Tonga Trench (at 15°10'S) is probably linked to the Fiji Fracture Zone, trending east-west north of Fiji, but the trench ends in a complex transition from subduction to a strike-slip motion and seismicity patterns indicate a presence of a c. 100 km (62 mi)-broad transition zone rather than a simple transform fault. In or near this zone there is a ridge-ridge-ridge triple junction ( 15°37′S 174°52′W / 15.617°S 174.867°W / -15.617; -174.867), known as the King’s or Mangatolu Triple Junction (MTJ), characterised by deformation and recent and intense volcanism (see for example Home Reef). The Tofua volcanic arc on the northern Tonga Ridge extends to less than 40 km (25 mi) of the trench's northern end. [14]

Just north of the MTJ lies the south-north-trending Northeast Lau Spreading Centre (NELSC) which intercepts the northern end of the Tonga Trench and is one of three major spreading centres in the northern Lau Basin (together with the Futuna Spreading Centre and Northwest Lau Spreading Centre.) The maximum spreading rate in the NELSC is 94 mm/a (0.117 in/Ms) but spreading decreases to zero at either end of the spreading centre. The total spreading rate between the Tongan and Australian plates, however, is 157 mm/a (0.196 in/Ms) and additional microplates and/or deformations zones must thus exist. The NELSC probably receives magmatic contributions from the Samoa hotspot. [15] The NELSC has a morphology which is similar to those of slow-spreading ridges with many closely packed ridges and troughs reaches. Where it meets the trench a ridge-transform-transform boundary is developing between the Tonga Ridge, the Pacific Plate, and the Australian Plate. [14]

North-east of the 60° bend in the Tonga Trench the Pacific seafloor is full of parallel lineations. These have been interpreted as remnants of an extinct, east-to-west-trending spreading centre on the Pacific Plate, much older than the Tonga Trench. [14]

Louisville Seamount Chain collision

At its southern end ( c. 26°S) the Tonga Trench is colliding with the Louisville Seamount Chain, a chain of guyots and seamounts on the Pacific Plate roughly parallel to the Hawaiian–Emperor seamount chain in the northern pacific. The Louisville collision zone migrates southward at a rate of 18 cm/year (7.1 in/year) because of the difference in the oblique angel between the Louisville ridge relative the direction of convergence. In the eastern Lau Basin spreading centres are propagating southward at roughly the same rate. The collision zone also offsets the Tonga Trench to the north-west relative to the Kermadec Trench by c. 50 km (31 mi). [7] The subducting Louisville Ridge has caused a significant amount of erosion on the outer edge of the southern Tonga fore-arc and has probably accelerated subsidence in the Tonga Trench, a process which makes the Tonga Trench the second deepest trench on Earth and considerably deeper than the Kermadec Trench. [16]

The oldest and westernmost of the Louisville seamounts, the Osbourn Seamount, is sitting on the edge of the trench and its former flat top is currently tilting towards the trench. [17] West of the Osbourn Seamount a broad zone of faulted blocks shallows the trench by 3,000 m (9,800 ft) while the adjacent fore-arc is elevated by c. 300 m (980 ft) and covered by canyons. [18]

The Louisville collision zone correlates with a zone of seismic quiescence along the Tonga-Kermadec Trench known as the "Louisville Gap". This gap in seismicity indicates that subducting seamounts inhibit or even prevent seismicity at subduction zones, perhaps by increasing intervals between earthquakes, but the mechanism behind this process is poorly understood. [19]

Geochemical evidence suggests that the Louisville chain has been subducting under the Tonga-Kermadec Arc since 4 Ma. Seismic studies have identified a southward, along-arc mantle flow that indicate that Pacific mantle is being replaced by Indo-Australian mantle west of the Tonga trench. [20]

Osbourn Trough

The Osbourn Trough, located at 25.5°S just north of the Louisville Ridge collision zone, is a 900 km (560 mi)-long extinct spreading ridge located midway between two large oceanic plateaux north and south of the Tonga Trench respectively: Manihiki 1,750 km (1,090 mi) to the north and Hikurangi 1,550 km (960 mi) to the south. These plateaux once formed part of the 100×10^6 km3 (3.5×1018 cu ft) Ontong Java-Manihiki-Hikurangi large igneous province (LIP). Spreading between the plateaux ceased when Hikurangi collided with the Chatham Rise east of New Zealand at 86 Ma. [21] The western end of the Osbourn Trough is bounded by the Tonga Trench and its eastern by the Wishbone–East Manihiki Scarp. In between the Osbourn Trough is divided into three segments separated by dextral offsets. Near the Tonga Trench the bathymetry of these structures is affected by the bending of the Pacific Plate. [22]

Capricorn Seamount

The Capricorn Seamount is a guyot located on the eastern wall of the northern Tonga Trench (see map above). It is a large guyot, 100 km (62 mi) wide at its base with a small part of its reefal or lagoonal summit reaching 440 m (1,440 ft) below sea level. The bending of the Pacific Plate at the Tonga Trench is currently slicing it like a loaf of bread: inside the guyot a north-south-trending horst and graben system is developing parallel to the trench; the western slope of the guyot has reached the 9,000 m (30,000 ft)-deep trench and has started to fill it; the summit of the guyot is tilted 1.7° towards the trench and its centre is only 45 km (28 mi) from the trench axis. [23] The Capricorn Seamount is expected to be completely consumed by the trench within 500,000 years. [24]


TONGA TRENCH INFORMATION

Tonga ... Trench ...

POPULAR VIDEOS AND PHOTOS



POPULAR ONLINE SOURCES

Google | Yahoo | Bing | DuckDuckGo | Ask | Aol | Facebook | Twitter | Linkedin | The New York Times | Yelp | Buzzfeed | US Weekly | RollingStone | WebMD | The Verge | HubPages | PlayBuzz | ESPN



  ↑ TOP OF PAGE ↑  


© Computer Services Express